© 2019 BY ULYSSIX TECHNOLOGIES, INC.

7470 New Technology Way, Suite B  |  Frederick, MD 21703

301. 846. 4800  |  telemetry@ulyssix.com

 

GryphonRF

Data Link Analyzer w/ Optional Noise Source for Eb/N0 Measurements

 

Continuing with the Ulyssix™ style of innovation, the GryphonRF™ is a first of its kind. A data link analyzer complete with noise, jitter, latency, and re-sync test modes all the while providing precise bit error rate calculations. The GryphonRF™ saves the operator time, by allowing manual or automatic test operation.

 

Analyze a system’s ability to recover from a variety of common signal interference. In Eb/N0 Noise Mode, measure a systems tolerance to a noisy signal by selecting the noise level from -32dB to 0dB. Inject FM jitter to a PCM stream to simulate a common phenomenon seen when playing data off of tapes. Re-Sync Mode, measure how long a system takes to recover lock upon loss. Measure round trip link delay of a system in Latency Mode.

 

The GryphonRF™ combines the versatility of the Tarsus3™ PCM simulator with the reliability of a custom made calibrated noise module. This pairing provides the user with an unmatched level of precision. The ease of use in the Tarsus3™ is not lost in the Gryphon™. The user has the ability of selecting from pre-stored data patterns, the fully programmable PCM simulator, or playing a previously archived Tarsus Archive Data file.

 

The GryphonRF™ system is controlled via the dual capacitivie touch screen displays or through Ethernet connection to a host computer. The Gryphon200™ main graphic display allows for easy setup of test parameters and real-time viewing of test results. View and print complete test reports from the host computer.

 

As with all the Ulyssix™ products, all Field Programmable Gate Array (FPGA) firmware upgrades to the internal Tarsus3 are done via the Gryphon200™ internal software interface via the USB port.

 

Data Link Features

  • Fully programmable PCM simulator or prestored patterns

  • Bit rates programmable from 1 bps to 40 Mbps

  • Supports all IRIG code types (NRZ-L/M/S, BiP-L/M/S, RNRZ-L, RZ)

  • Large Graphic Display for data entry or real-time viewing of test results

  • Easy to use front panel keypad for data entry

  • Composite output level programmable from 0.1Vpp to 5Vpp in 0.1V increments

 

Test Features

  • Wideband noise generator

  • Noise source calibrated out to 50 MHz

  • Noise programmable from -32dB to 0dB with 0.1dB increments

  • Eb/N0 readings with Waterfall Diagram and report

  • C/S/L/P/IF Band Receiver FM/SOQPSK

  • C/S/L/P/IF Band Single Channel Modulating RF Signal Generator

  • Simulate FM Jitter commonly seen on PCM tape playback

  • Latency test provides readback of round trip link delay

  • Resync test shows bits from loss of sync to re-acquisition